Mark-10 BG200 Digital Force Gauge

Description

Features
The Mark 10 BG Digital Force Gauge is an advanced force measurement solution with sophisticated measurement capabilities, data outputs, computer control capabilities, and a long list of features and configurable settings. The BG can stop motorized test stand travel at user-selectable set points, and can also prevent force overload (when used with the ESM motorized test stand). Go / no go testing can also be accomplished with an optional plug-in hi / lo limits indicator.
Features:
Compatible with all Mark 10 test stands and grips
RS-232, Mitutoyo and analog outputs
GCL-Gauge Control Language for full computer control
Automatic timed output on RS-232
Dual set points with outputs
Averaging mode for average readings over time
External trigger for contact or switch testing and data capture
General purpose I/O for external device control
Programmable analog and digital filters
Selectable units of measurement
Programmable default configuration
Peak memory for tensile and compressive forces
Push-button calibration
Battery or AC operation
Programmable automatic shutoff
Reversible aluminum housing for handheld use or test stand mounting (see below)
Same housing size for all capacities
Specifications
Accuracy: ± 0.2% of full scale ±1 digit
Sampling rate: 65 readings/sec
Display rate: 25-10/sec, 65/sec in peak mode
Display: 4-1/2 digit, 0.3 inch (7.6 mm) high LCD
Indicators for low battery , units and mode of operation
Power: AC or rechargeable battery with IPM, a 3-step Intelligent Power Management system that warns the user via LO BAT indicator and then will shut off the gauge
RS-232 - Fully configurable up to 9600 baud. Includes GCL (Gauge Control Language)
Mitutoyo output - Serial BCD suitable for all Mitutoyo SPC-compatible devices
Analog output - +/-VDC +/-0.25% of full scale at capacity. Positive for compression, negative for tension
Set point outuputs: 3 open collector lines (utilizing Mitutoyo lines)
General purpose I/O: 3 open collector outputs and one input (utilizing Mitutoyo lines)
Sensor detection: 0.010 (0.25 mm) maximum deflection at full load
Safe overload: 150% of capacity - display shows == at 110% and above
Battery life: 8-10 hours per charge
Weight - Gauge only: 0.9 lbs (0.4 kg)
Environmental requirements: 40°F - 100°F [5°C - 45°C], <96% humidity (non-condensating)
Shipping cost is determined by buyer's location.
OR you may arrange your own transportation.
If your transportation company does not require this unit to be
on a pallet for shipping there will be no palletizing fee.
Michigan
residents will be charged 6% sales tax for this item.
BG200
200 x 0.1 lb, 100 x 0.05 kgF, 1000 x 0.5 N, 110V